I have modified some RX holders from @Flonase (See here) For installation on the rear of TMY and it should have the same corrective angles for TM3 (Gen1).
The TX holders are from scratch.
These are designed to be installed offset from center, square, and with ~0-0.5% upward tilt. The "tall" side goes in towards the plate. Different suspension geometries may lead to some angle variations.
These are designed to accommodate a 1RX+1TX, 2RX or 2RX+1TX install (with flat TX...
Read more
The TX holders are from scratch.
These are designed to be installed offset from center, square, and with ~0-0.5% upward tilt. The "tall" side goes in towards the plate. Different suspension geometries may lead to some angle variations.
These are designed to accommodate a 1RX+1TX, 2RX or 2RX+1TX install (with flat TX...
Read more