Here is my introduction plus install for everyone. Might as well get it done all at once. I work for a 12v Electronics distributor in Canada and this will be used as a demo for dealers/customers.
I have "finished" the install on my Uniden R9. I still need to figure out the rear laser headed and a better mount for the controller.
Everything was fabricated using Fusion360 and printed on a Bambu labs 3d printer. Used ASA and primed and painted after. I ended up investing far more time then I...
Read more
I have "finished" the install on my Uniden R9. I still need to figure out the rear laser headed and a better mount for the controller.
Everything was fabricated using Fusion360 and printed on a Bambu labs 3d printer. Used ASA and primed and painted after. I ended up investing far more time then I...
Read more